Close

Floor lamp cleaning and maintenance tips can extend the service life

10-09

More and more families are using floor lamps, because floor light tend to reveal a low-key yet elegant temperament, and are easy to move and suitable for the placement of furniture. So do you know how to clean floor light? How to maintain the floor light? The following briefly describes the cleaning and maintenance methods of floor lamps in life.
      
Cleaning method:
One . If the lamp is non-metallic, you can wipe it with a damp cloth to prevent dust from accumulating and affecting the lighting effect.
      
two. The maintenance work of floor light is mainly to prevent moisture. In order to prevent moisture intrusion and avoid rust damage or leakage and short circuits, it is necessary to install moisture-proof lampshades, especially those installed in toilets, bathrooms, kitchens and other places.

three . When cleaning the lampshade of thefloor light, use a clean feather duster to gently sweep away the dust and try not to deform the lampshade. The lamp shade is easier to accumulate dust and cause darkening, so it is necessary to clean and take care of the lamp shade regularly.
          
four. Never use water to clean the lamp, just wipe it with a clean cloth dipped in water. If you accidentally touch the water, you need to wipe it off with a dry cloth immediately, remember to turn off the light before wiping.


3.jpg


Maintenance skills:
One. Moisture-proof. The most worrying thing about electrical appliances is moisture, which will not only reduce their service life, but also be dangerous to electricity. Therefore, the maintenance of floor light is mainly to prevent moisture. Whether the floor light is placed in the living room, bathroom, bathroom, or kitchen, moisture-proof lampshades must be installed to prevent moisture intrusion, so as to avoid rust damage or leakage short circuits.
           
two. Dust removal. The maintenance of the floor light should be done regularly and frequently, especially the lampshade of the floor light. The lampshade is easier to accumulate dust and cause the lighting effect to dim, so it should be cleaned frequently. And when cleaning the lampshade of the floor light, use a clean feather duster to gently sweep away the dust, so as not to deform the lampshade.

three. Do not switch frequently. Do not switch frequently when using the lamp, because when the lamp is frequently started, the current of the filament will be larger than the current during normal operation, which will make the temperature of the filament rise sharply and accelerate the sublimation, which will consume the filament. Life, so it is necessary to minimize the number of times the lamps are switched on and off.

Disclaimer: This article is reproduced from other media. The purpose of reprinting is to convey more information. It does not mean that this website agrees with its views and is responsible for its authenticity, and does not bear any legal responsibility. All resources on this site are collected on the Internet. The purpose of sharing is for everyone's learning and reference only. If there is copyright or intellectual property infringement, please leave us a message.
©Copyright 2009-2020 Apocalyptic daily      Contact Us   SiteMap